Trade guideline for installation for E-Brick
The major benefit when fitting E-Brick panels is that they are easy, quick and clean. The stages of installation when fitting E-Brick panels are described below.
Fit a corner slip to the wall so that you start from a flat, clean base. The E-Brick system can be fitted to almost any existing outside wall.
Separate insulating corner slips are screwed on to cover the corners of the wall.
Attach the E-brick panels using stainless steel screws in the holes provided. The holes are drilled during manufacture. As standard, holes must be drilled for 9 screws. The higher the location of the work to be carried out, the higher the number of holes.
Apply silicon to the joints between the E-Brick panels to guarantee all is waterproof.
The corners of the wall, windows and doors are finished with corner slips supplied in the same colour of brick. Connecting slips are also fitted between individual E-Brick panels to finish the wall off. These slips and corner pieces are sustainable glued to the insulating layer.
When all panels, connecting slips and corner pieces have been fitted, the ensemble is pointed with a selecting grouting of choice.
The extensive range of colours of facing brick means that there is also a wide range of E-Brick colour available. There are two sizes of facing brick available in the E-Brick range: WF50 (215x50x20mm) and WF65 (215x65x20). In the E-Brick System, a 10mm wide joint us always provided. Zero or joint-free installation is not possible with this system.